Shower Installation in Eastbourne

Many Eastbourne properties have older systems. Combi boilers work well with mixer showers if pressure is decent. If you've got a hot water cylinder in the airing cupboard with a cold tank in the loft, you might need a power shower or electric shower for good flow.

Victorian and Edwardian houses in Old Town often have solid walls that are harder to chase pipes through. If you're adding a shower upstairs, we need to check the waste can reach the soil stack without crossing too many joists.

Electric showers need their own circuit from the consumer unit. Older properties may need a consumer unit upgrade first. We'll do the plumbing but you'll need a qualified electrician for the electrical connection - we can recommend local ones we work with regularly.

New shower installations in rooms without existing drainage often need Building Control approval. Converting bedrooms to en-suites or adding showers to downstairs cloakrooms typically requires notification. We'll advise if your project needs it.

Many pre-1970s homes around Meads and Old Town still have lead supply pipes. These need replacing before installing new shower systems. We'll check your incoming supply and advise if upgrade work is needed before we start the shower installation.

Concrete floors in 1960s properties and flint walls in older Eastbourne houses make pipe runs more complex. We might need to run pipes externally or in boxing rather than buried in walls. This affects the installation time and approach.

Many properties around Upperton and Town Centre have been converted to flats. Connecting new shower waste to shared drainage systems needs careful planning to avoid affecting other properties and meet water authority requirements.

Properties on higher ground near the Downs often have excellent mains pressure, while seafront areas can suffer from lower pressure during peak times. We'll test pressure at different times if you're experiencing variable flow from existing taps.

If you're retiling or refitting your bathroom, it's the ideal time to upgrade shower systems. We can run new pipework before tiling starts and coordinate with your bathroom fitter to ensure everything connects properly when the new shower unit arrives.

If your current shower barely trickles or temperature fluctuates wildly when taps are used elsewhere, a new system with proper pressure balancing or a pump might solve the problem. We'll assess whether your pipes, boiler, or shower unit is the issue.

Many older Eastbourne properties only have baths. Adding a shower over the bath or installing a separate shower cubicle increases property value and practicality. We'll assess space, drainage options, and water supply to recommend the best approach.

Converting spare bedrooms or extending into loft spaces often includes en-suite showers. We'll check the water supply can reach upper floors with adequate pressure and ensure waste can connect to existing drainage without issues.

Running new pipework from the kitchen or airing cupboard to upstairs bathrooms requires more materials and labour. Properties with central heating pipework nearby often have easier connection points, reducing installation complexity.

Shower waste needs a fall of at least 1 in 40 to drain properly. If the soil stack is far away or at the wrong level, we might need to install a shower waste pump or run pipes externally - both add to installation complexity.

Chasing pipes into solid walls takes longer than running them through stud walls. If walls have just been plastered or tiled, you might prefer surface-mounted pipework in boxing to avoid damage - though this affects the finished appearance.

Installing power showers with old hot water cylinders might need cylinder upgrades. Combi boilers sometimes need flow rate checks. If your stopcock or internal plumbing is very old, upgrading these first might be sensible for long-term reliability.